How to keep the laser cutting machine in optimal operation

How can the laser cutting machine achieve the best working condition in the process of application? As the operator, the quick completion of the cutting is an important part of our improvement of efficiency, we should understand the operation method and principle of the laser cutting machine, and The laser equipment can be adjusted at any time to ensure normal operation!

Reasonable installation of the laser tube fulcrum, if the device is unreasonable, the laser tube spot form will be deteriorated, and then several spots will appear after a period of operation, which seriously affects the normal operation of the device and forms a phenomenon of frequently changing the laser tube. . The cooling system should be grounded. The water tank and waterway should be cleaned frequently. The temperature control point of the cooling temperature control water tank should be correct. Otherwise, the laser tube will be damaged and the dew condensation power will drop, the cold head of the tube will fall, and the life expectancy will be greatly shortened. Change the tube.

The suction device should be checked and arranged on time, and the fan ducts should be cleaned. Otherwise, some smoke dust will not be discharged, which will intensify the pollution of the lens and the damage of the laser tube, so that the mechanical and electronic components are easily oxidized to form a touch.

Water protection should always be checked for cleaning. Cooling water often cannot be opened. Water protection float switch or water protection float switch is not reset. Short-circuit method cannot be used to solve the urgent need.

laser cutting

The working environment of the laser cutting machine can't be too bad. If the ambient temperature is higher than 30 degrees, below 18 degrees, there is too much dust and the air quality is too bad, so the machine will be seriously damaged and the rate will rise continuously; In the humid environment, the electrical components of the seat cover laser cutting start are very prone to problems.

Focusing mirror and mirror view, the frame will be hot for a while, the lens surface will be discolored and rusted; the film peeling and cracking will need to be replaced in time, especially the equipment is using atmospheric pump and air compressor, so that it will be focused during the operation. There will be water on the lens soon, so it is necessary to check the cleanliness and quality of the lens light path system on time.

The power grid power should be matched.

The laser tube operating current should be correct, and it can't work under the light intensity of 90-100 for a long time; it is necessary to apply laser and save laser energy reasonably; the optical path system should be clean, otherwise it is easy to make the laser tube premature, and advocate the working light of laser cutting machine The strength should be adjusted at 50-60%, and the working speed of the equipment should be adjusted according to the specific conditions of the processed materials to achieve the best working condition.

The above points are the matters that our laser equipment operators need to know and pay attention to. In the operation, we should ensure the normal operation of the laser equipment as much as possible. The daily protection work is essential, so as to reduce the equipment problems as much as possible and ensure the durability of the laser cutting machine. Running.